First, the laser head does not shine
1. Press the operation panel test button to check the status of the ammeter:
1 No current: Check if the laser power supply is connected, whether the high voltage line is loose or falling off, and whether the signal line is loose;
2 There is current: check if the lens is broken and the optical path is seriously offset;
2. Check if the water circulation system is normal:
1 No water: Check if the pump is damaged or not energized;
2 water supply: check whether the water inlet and outlet are reversed or the water pipe is broken;
3, can shoot, can self-test, send data does not shine (check if the computer settings are correct)
Second, the carving is not deep or not deep
1. Check whether the water circulation system is flowing smoothly (the water pipe is bent or the water pipe is broken);
2. Check if the focal length is normal (recalibration);
3. Check if the optical path is normal (recalibration);
4. Check if the paper on the plate is too thick and the amount of water is too much (re-corrected);
5. Check if the beams are parallel (adjust the belts on both sides);
6. Check if the lens is broken (replace);
7. Check whether the lens or laser tube emitting end is contaminated (re-cleaning);
8. Check if the water temperature is higher than 30 °C (replace circulating water);
9. Check if the laser head or focusing mirror is loose (tighten);
10, the laser current intensity must reach 8mA;
11, laser tube aging (replacement: no charge during the warranty period);
Third, the reset is not normal
1. Check the sensor for ash, poor contact or damage (wiping the dust or replacing the sensor);
2. Check if the flexible tape data cable is in poor contact or damaged (pruning the data cable to re-plug or replace the data cable);
3. Check if the ground wire contact is reliable or if the high voltage wire is damaged (re-ground or replace the high voltage wire);
4. Poor contact of the motor line.
Fourth, the leak
1, the initialization is incorrect, the data has been sent (corrected);
2. The operation sequence is reversed (re-output);
3, static interference (check if the ground wire is off);
5. Cleaning the hook and dislocation, not closing
1. Is the edited file correct (re-editing);
2. Whether the selected target is over published (reselected);
3. Check if the software parameter settings are correct (reset);
4. The computer system is incorrect (reinstall the operating system and software);
5. Check if the left and right belts are tight or the back belt is too loose (the belt is tightened);
6. Check if the belt or the synchronous wheel is slipping or skipping (tightening the synchronous wheel or belt);
7. Check if the beams are parallel (re-adjust the left and right belts);
Sixth, the computer can not output
1. Check if the software parameter settings are normal (reset);
2. Whether the engraving machine starts and then outputs according to the positioning (re-output);
3. Check if the machine has not been reset beforehand (re-correct);
4. Check if the output serial port is consistent with the software setting serial port (reset);
5. Check if the ground wire is reliable and whether the static electricity interferes with the data line (re-ground);
6, replace the computer serial output test;
7. Reinstall the software and reset the test;
8. Format the computer system disk and reinstall the software test;
9, the motherboard serial port damage needs to be repaired or replaced.
Seven, can not calculate the path
1. Check if the calculation method of the set path is correct;
2. Check if the graphic file format is correct (re-correct);
3. Remove the software and reinstall it and set it up;
Eight, computer FAQ
1, the font is gradually reduced (reinstall the operating system);
2, the amount of data is too large to calculate the laser path (wait for a while or increase the computer memory);
3. The calculation path does not respond for a long time, restart the computer test.
8. Format the computer system disk and reinstall the software test;
9, the motherboard serial port damage needs to be repaired or replaced.
